Page 1 of 1

Two way communication between reaktor and lemur ipad

Posted: 02 Feb 2012 05:50
by samgreene
Hi,

I've got the stand alone version of reaktor working and have set up OSC as shown in the tutorial video. I can control reaktor from the lemur, but the lemur is not being updated when reaktor changes - if I were to change a preset or mouse a change in a control. From the look of the video, it seems that lemur changes to reflect the patterns switching. I got the IP and port of the lemur application from the lemur designer application and entered that into reaktor as well. Not sure what to try next if this should in fact be working.

I'm connected over a wireless router.

Thanks
Sam

Re: Two way communication between reaktor and lemur ipad

Posted: 02 Feb 2012 05:56
by samgreene
Popped open wireshark to see what's actually going on and I do see OSC UDP messages being sent to the iPad IP address on port 8001.

Re: Two way communication between reaktor and lemur ipad

Posted: 02 Feb 2012 06:27
by Macciza
Hi
Try sending to 8000 instead . . .
Cheers
MM

Re: Two way communication between reaktor and lemur ipad

Posted: 02 Feb 2012 09:51
by lABl
Yes, please check Macciza's advice port 8000 instead 8001.

Also a very important thing is the "Identifier Name", it should be Lemur

Here a very good tutorial by Liine in case somebody need it:

REAKTOR | LEMUR OSC SETTINGS
http://www.youtube.com/watch?v=iKtmYnCdjcQ

Cheers,

Re: Two way communication between reaktor and lemur ipad

Posted: 03 Feb 2012 04:16
by samgreene
Macciza wrote:Hi
Try sending to 8000 instead . . .
Cheers
MM
Thanks - that IS what it said in the tutorial. I got the port from the lemur editor, which seems to be a port for that sort of communication.

Thanks!!

Re: Two way communication between reaktor and lemur ipad

Posted: 03 Feb 2012 05:32
by sun in aquarius
I followed that exact tutorial and i get no communication....

Re: Two way communication between reaktor and lemur ipad

Posted: 03 Feb 2012 09:25
by lABl
Sorry, I am confused now, in other post you're saying you cant open the ensembles because "not a valid file" message, please may you to post more details about you're using?
thanks,