Page 1 of 1

LED Feedback?

Posted: 27 Jan 2012 04:50
by jaredfmylife
Hello,

I've seen some similar posts but still no answers. I'm trying to have the color change depending on the state of the toggled button.

So in traktor I have a button that is toggled with a midi cc. I can then have the state of the button back to my midi device, it works on a X1 controller but not with my lemur. When I set the button up as a bad it doesn't stick on the color and the toggle in lemur doesn't reflect the correct state.

For example if I use the mouse to turn off a function the lemur doesn't reflect the change in state.

Please advise,

-Jared

Re: LED Feedback?

Posted: 27 Jan 2012 14:52
by brianc
Do you have Traktor outputting that same CC when the parameter is touched? That should take care of it.

Re: LED Feedback?

Posted: 28 Jan 2012 23:49
by jaredfmylife
Yeah I do. I've used the mapping on a traditional control service that utilize LEDs and its not working. I'll move a fader on traktor and its not updated on the device. Could it be a setting with icontrolmidi?

Re: LED Feedback?

Posted: 29 Jan 2012 18:01
by brianc
Probably the next thing I'd look at is if Lemur is configured to both send and receive midi to/from the computer. I've had situations where the receive link wasn't working for some reason (my fault, I'm sure), and Lemur wasn't getting updated.