Lemur and LoopMIDI in Win7

[Buttersalt]

Trying to connect Lemur via Wifi from iPad 2. Have now installed both LoopMIDI and MIDI Yoke on PC (Win 7 x64). Opening the Lemur Daemon shows empty ports, though if I try to use the "Add" button both Loop MIDI and MIDI Yoke ports are listed. If I open the LoopMIDI setup and add a port (I've been starting with 2 ports to avoid feedback) the added port flashes in the Daemon Setup and then quickly disappears.

I guessed that somewhere a MIDI loop was happening, but I've now gone through all applications as far as I know and disabled anyof the LoopMIDI and MIDI Yoke ports, but still same results.
Any clues?
Sending help request to LoopMIDI as well.
Thanks

[Buttersalt]

Found a solution. I'd tried a couple ways with the Windows wireless ad-hoc setups and then with Connectivity, but without allowing Internet Connection. Finally tried that and Lemur on iPAd connected and the LoopMIDI ports began to show up correctly.

I was getting connection indications that would seem to indicate I was connected, but I really wasn't. Not sure why that was happening.

Jeff