Page 1 of 1

Mac OSX Daemon Setup Problem

Posted: 12 Dec 2011 21:04
by mscoelho
When I try to set up the ins an outs on the iPad, I don't see all of the virtual midi connections listed, only "Session 1". I'm picking "Session 1" for both in and out. I'm getting feedback from Ableton to Lemur, but I can't send from the iPad to Ableton. My adhoc network works with Touchable. I can send templates from the editor to Lemur. Any ideas what is wrong?

Re: Mac OSX Daemon Setup Problem

Posted: 19 Dec 2011 13:49
by mscoelho
After further experimentation and research, I figured out that I was able to connect through a router, so the problem was the adhoc connection. I found that if I put the iPad into airport mode, then enabled WiFi and connected to my adhoc network, I was able to successfully connect Lemur to my Mac.