Page 1 of 1

Saving state? Snapshots?

Posted: 11 Dec 2011 03:43
by peterdines
Is there a way to save snapshots / presets / banks for a Lemur template or page? I'm stumbling into these incredible sounding granular patches in Reaktor but because they depend on things like the current multiball trajectories as LFOs, they'll just disappear... lost... like tears... in the rain. :cry: :lol:

Re: Saving state? Snapshots?

Posted: 11 Dec 2011 16:11
by misal
I don't know whether it's what you're looking for, but here is an article about storing:
http://www.jazzmutant.com/workshop_tuto ... id=storing

Hope this helps.

Re: Saving state? Snapshots?

Posted: 12 Dec 2011 15:02
by peterdines
Thanks, that seems cool but provides a limited number of slots... what I might end up doing is putting the storage on the computer side, in Reaktor, and send updated control values from there via OSC on snap change. I already do something similar with TouchOSC so it should work with Lemur too.