Making 16 switches where only one switch is lit at a time
Posted: 05 Oct 2017 02:21
Hello All,
I am very much a beginner at Lemur and scripting. I went htrough a few basic tutorials, but here is what I wanted to achieve for my setup -
16 switches sending 16 CC values (0,8,16,24,32..) of CC0 but with only the last pressed switch being lit. Having only one switch lit at a time. Is this something achievable with the pads?
I tried making columns out of a single switch, put the Radio option on, which works the way I want it on the interface, but I cannot seem to assign different CCs/values to the different columns in the editor. The whole switch with the columns gets selected when clicked.
So then I went on to successfully assign 16 switches to send 16 values, but now they all remain lit, until I press them again.
Can someone help me with this? Sorry for being such a noob.
Thanks!
I am very much a beginner at Lemur and scripting. I went htrough a few basic tutorials, but here is what I wanted to achieve for my setup -
16 switches sending 16 CC values (0,8,16,24,32..) of CC0 but with only the last pressed switch being lit. Having only one switch lit at a time. Is this something achievable with the pads?
I tried making columns out of a single switch, put the Radio option on, which works the way I want it on the interface, but I cannot seem to assign different CCs/values to the different columns in the editor. The whole switch with the columns gets selected when clicked.
So then I went on to successfully assign 16 switches to send 16 values, but now they all remain lit, until I press them again.
Can someone help me with this? Sorry for being such a noob.
Thanks!