Page 1 of 1

fader visual accuracy Ableton

Posted: 31 Dec 2016 09:16
by drain
Hello, i have a strange Problem

i have some track volume Faders assigned in ableton.

If i move them after releasing they sometimes move a tiny bit afterwards.

in midi monitor i can see

Ableton sends from 0 -127, so does the Lemur Fader
the last value sent by Lemur is the same as the last value sent by Ableton to Lemur.

it seems the visual position of the fader cap is not always the same if a value is send or reveived

Re: fader visual accuracy Ableton

Posted: 31 Dec 2016 13:41
by oldgearguy
It's likely due to rounding. The faders use many decimal places of precision and depending on how the math is done and how much rounding is happening, the value may be slightly different than before.

Re: fader visual accuracy Ableton

Posted: 10 Jan 2017 05:32
by drain
seems like your right

if i use pitch control instead of cc i don't get this effect at all
this feels just so much better, unfortunately i can use pitch only if i use a MCU script in ableton
so the solution would be a Lemur update so i can choose between 7 and 14 bit, or a possibility to make the grid option go up to 127 on faders and knobs....instead of just 33
because in grid mode enabled i doesn't happen as-well

means i better forget about it and take what i have :D