Page 1 of 1
Need help with something again
Posted: 22 May 2016 18:37
by digitalson
Ok is there a way to use a mouse click command when opening up a tab or container?reason why in cubase the commands for project and mixer won't work unless they are in focus,so if I enter the mixer tab the mouse can click on it to bring it in focus for the entire tab of commands and same going back to project window,,,,,,any thoughts?
Re: Need help with something again
Posted: 24 May 2016 00:39
by digitalson
Cmon ,almost done with the ultimate cubase project
Re: Need help with something again
Posted: 06 Jun 2016 21:22
by Softcore
mouseout(target, x, y)
or
clickout(target, x, y)
Re: Need help with something again
Posted: 07 Jun 2016 20:39
by digitalson
Thanks soft core but I need to have that function happen when I open the tab ,how can I make that happen?
Re: Need help with something again
Posted: 07 Jun 2016 20:44
by digitalson
And on mouse out and click out what is target?
Re: Need help with something again
Posted: 07 Jun 2016 20:47
by digitalson
Is that midi Num? X and y are position,and click out is 1 for click and hold and is 2 double click? Never understood that ,cause the manual is not correct on that
Re: Need help with something again
Posted: 16 Jun 2016 19:15
by digitalson
Cmon software type ur magic
Re: Need help with something again
Posted: 20 Jun 2016 19:54
by digitalson
I meant softcore ,,,,give me some of your magic,I am almost done with the best cubase lemur project ever!!i cannot work with out it
Re: Need help with something again
Posted: 24 Jun 2016 22:58
by CSharpDude
Maybe a macro in Cubase and call it from Lemur? Just a thought...
Re: Need help with something again
Posted: 26 Jun 2016 01:12
by digitalson
Well I need lemur to send mouse commands from the tabs to put focus on the window that the key commands are going,so if there is a way to get lemur to mouse click on a window from opening a tab