Legacy lemur freeze
Posted: 20 Aug 2015 17:20
Hello!
This is the only forum i found that still talks about legacy lemur, so i'll try my luck here despite the lack of posts and support on the legacy forum.
I've been a long time user of legacy lemur. Everything was working ok until a couple of months back.
Out of the blue, my lemur just started to freeze minutes after i start working (both midi and osc). If i turn it off, then on again I get a black screen with only the 2 buttons on the middle red (page and previous page buttons). If i wait a little bit and try again, it starts ok, then i start working and a few minutes later - freeze!!!
I try to replace the power supply and ethernet cables but the issue is still happening. I'm on mac osx 10.8.5 and 10.9.5 (but i think this is not the problem). I think it is an issue with ethernet, but i cannot figure it out :/
Is my lemur dying? Anyone else had this issue?
Thank you!!!!
This is the only forum i found that still talks about legacy lemur, so i'll try my luck here despite the lack of posts and support on the legacy forum.
I've been a long time user of legacy lemur. Everything was working ok until a couple of months back.
Out of the blue, my lemur just started to freeze minutes after i start working (both midi and osc). If i turn it off, then on again I get a black screen with only the 2 buttons on the middle red (page and previous page buttons). If i wait a little bit and try again, it starts ok, then i start working and a few minutes later - freeze!!!
I try to replace the power supply and ethernet cables but the issue is still happening. I'm on mac osx 10.8.5 and 10.9.5 (but i think this is not the problem). I think it is an issue with ethernet, but i cannot figure it out :/
Is my lemur dying? Anyone else had this issue?
Thank you!!!!