MIDI Kinetics Forum

Is it possible to control two daws on seperate computers with this program? and why does ableton refuse to see lemur but lemur works with third party virtual midi ports.

IF its possible i cannot for the life of me do it. I tried to add him to lemur out 0 on daemon remote port and it kicks me off the port. Sorry if i make little sense i am pretty new to the program.

(for setup)
try searching around a little, there are lots of demonstrations.

But if you want to connect MIDI through daemon:
-open lemur daemon and go to setup
-Add your input and output MIDI ports
-choose the matching MIDI input in your ableton midi sync (so if it was '0' or whatever choose the lemur daemon input 0)
--turn remote on, like you said you did, if you want to MIDI assign cc #s in ableton
-should be able to midi assign stuff in ableton.

you may have already done this. Just double check your steps, maybe there is one little thing wrong... it's an easy setup once you got it.

--as for two daws, yes that's possible. You will make multiple targets is all.