Lexicon Bank Select
Posted: 21 Nov 2014 21:18
Hi guys,
This may seem like a total newb question, but I am 99% done with an editor my Lexicon MX400, but I cannot for the life of me get the bank select to work. Every other MIDI cc and program select assignment works perfectly, but I've tried every combination of pad, switch, custom button, and even faders/knobs that I can think of, but I cannot get it to switch between the User and Factory preset banks. The manual simply says that bank select is done via MIDI cc 32, with 0=Factory and 1=User. I've checked the hardware side and it's set to receive both MIDI and program changes (all of which are working flawlessly, aside from cc 32). I've also tried using monitors to make sure that I'm sending the right values. The MIDI activity light on my iRigMIDI is showing that it's sending the message and the monitor indicates that it's the right values, but the hardware isn't responding. I'm probably just overlooking something obvious, but any suggestions would be most welcome.
This may seem like a total newb question, but I am 99% done with an editor my Lexicon MX400, but I cannot for the life of me get the bank select to work. Every other MIDI cc and program select assignment works perfectly, but I've tried every combination of pad, switch, custom button, and even faders/knobs that I can think of, but I cannot get it to switch between the User and Factory preset banks. The manual simply says that bank select is done via MIDI cc 32, with 0=Factory and 1=User. I've checked the hardware side and it's set to receive both MIDI and program changes (all of which are working flawlessly, aside from cc 32). I've also tried using monitors to make sure that I'm sending the right values. The MIDI activity light on my iRigMIDI is showing that it's sending the message and the monitor indicates that it's the right values, but the hardware isn't responding. I'm probably just overlooking something obvious, but any suggestions would be most welcome.