Page 1 of 1

StepSlider - Ramp??

Posted: 21 Nov 2014 03:02
by frankfurter
hi, can someone kindly explain a lil more in depth the ramp expression on StepSlider?

is it looking for values between 0.0 and 1.0 or what?

from what i've gathered, ramp is suppose to slowly change the values (or interpolate gradually) from step to step?
i tried a few different things and really didn't notice any difference when the ramp was set to 0 or something else.
i even slowed down the sequencer division to like 1/2 and 1/1, thinking that the steps were advancing too fast to really see the ramping.

thanks yooo.

Re: StepSlider - Ramp??

Posted: 21 Nov 2014 15:16
by Softcore
It is to interpolate between the values of two consequtive steps.
I think I had done some testing with my CCequencer project which confirmed this, although I do not clearly remember what I did.

Re: StepSlider - Ramp??

Posted: 21 Nov 2014 16:32
by frankfurter
yes you're right. i figured out what i was doing wrong this morning. nothing to do w/ the ramp itself.

now i see the sweeping change between steps! neatttto