How to get Lemur to send OSC messages and not OSC bundles
Posted: 29 May 2014 17:47
Hi,
I am trying to use Lemur to control my Behringer X32 digital mixer.
So far, I have been able to get TouchOSC to work perfectly, but Lemur will not work.
After lot's of trial and error, I now see that Lemur and TouchOSC are indeed sending the same exact message, but Lemur is packaging that message into a OSC Bundle while TouchOSC is just sending the message (/ch/01/mix/fader).
So I need to figure out how to tell Lemur to stop "bundling" this message and send it on it's own.
Any ideas?
I am trying to use Lemur to control my Behringer X32 digital mixer.
So far, I have been able to get TouchOSC to work perfectly, but Lemur will not work.
After lot's of trial and error, I now see that Lemur and TouchOSC are indeed sending the same exact message, but Lemur is packaging that message into a OSC Bundle while TouchOSC is just sending the message (/ch/01/mix/fader).
So I need to figure out how to tell Lemur to stop "bundling" this message and send it on it's own.
Any ideas?