Page 1 of 1
Output issue in Lemur 5
Posted: 04 Apr 2014 09:39
by leehu
Hi, pls see attached patch. The oscout command sends out the expect result, but the assignment to out always sends out 0. This was working fine in Lemur 4.
Can you take a look? thx
Re: Output issue in Lemur 5
Posted: 12 Apr 2014 02:33
by Macciza
Hi
Working fine in 5.0.2
section should be able to be used to send OSC, no need for the out = selection as such (except readability) as it is the same as selection . . .
Also remember the / if you want it to be proper OSC . . .
MM
Re: Output issue in Lemur 5
Posted: 14 Apr 2014 18:26
by leehu
great will check it out
they're only test patches so just looking to see what is output - not sposed to be proper OSC
thx