Page 1 of 1
new to lemur.. simple Q?
Posted: 13 Mar 2014 12:10
by dave dove
hey there
i want to use the range object to control two parameters in reaktor
i can see two strings of numbers, one for each end of the range
but i can't work out how to assign each end of the range to a separate parameter
is this possible?
dave
Re: new to lemur.. simple Q?
Posted: 13 Mar 2014 13:41
by Macciza
Hi
One way to do it is with MIDI Mapping.
Set your Target for the x values
Select Control Change as message
Set Controller to say 20 to 21
One end of Range slider will send CC20 the other will send CC21
Cheers
MM
Re: new to lemur.. simple Q?
Posted: 13 Mar 2014 13:59
by dave dove
Thanks
But using OSC
I can't get the second edge to map
I can see it working in theetphysical function template
I want to map the two edges to control sample position and length
But it will only map the first edge????
Dave
Re: new to lemur.. simple Q?
Posted: 13 Mar 2014 14:34
by Macciza
Hi
Best to mention as much info as possible, always . . .
Range sends an array
Make 2 vars, Position and Length in the Range object
Position = x[0] Length = x[1]
Map as needed
Cheers
MM
Re: new to lemur.. simple Q?
Posted: 13 Mar 2014 15:12
by dave dove
thanks
that works
dave