Page 1 of 1

Newbie question -- is there a way to convert incoming MIDI

Posted: 04 Jan 2014 14:13
by Mclagett
Hi --

Trying to determine if I should buy this software for my needs. Wondering if there is likely to be a straightforward way to map incoming Control Change messages from my foot pedal to the actual messages needed to control an ipad sequencer like Auria or Cubasis. For example, when my foot controller sends a CC message, can I have that end up being a real- time Start or Stop message by the time it reaches the sequencer on the iPad or perhaps an external device like my Roland Sonic Cell. If the answer is yes, then I will buy the software instantly.

Thanks for any help you can provide,

Regards,

Mike

Re: Newbie question -- is there a way to convert incoming MI

Posted: 05 Jan 2014 05:17
by Phil999
I haven't done conversions of MIDI signals yet with Lemur, but I'm pretty sure it will work.

But does the foot pedal output only CC? Anyway, a better approach might be a software like MIDITranslator (PC/Mac).

Re: Newbie question -- is there a way to convert incoming MI

Posted: 05 Jan 2014 16:27
by midimockup
Yes you can do it.

Unfortunately I don't have experience connecting hardware directly to the iPad. I think iConnectMIDI is what you need.

Re: Newbie question -- is there a way to convert incoming MI

Posted: 05 Jan 2014 18:13
by Phil999
MIDI interfaces/hardware MIDI connections are more reliable, but not necessary to receive, convert, and send MIDI.