Page 1 of 1

Mopho Dashboard Parameter Changes Ignored

Posted: 20 Dec 2013 20:46
by sculptair
I have connected the MIDI I/O ports on my Mopho desktop to the iConnectMIDI2+ MIDI DIN 1 port, and my iPad lightning port to the iConnectMIDI2+ USB 1 port using your cable and a lightning to 30 pin adapter. I have added the iPad as a MIDI 0 target in the app editor setup and chose ICM2 USB 1.1 in the "From" and "To" fields.

In the Mopho dashboard I have set the lemur device target as 0 and the MIDI output setting at 2 to match the setting on my Mopho. When I engage the Note Generation or a press a key on the virtual keypad of the Mopho dashboard, the Mopho will generate a sound. However all attempts to change any of the parameters of the Mopho dashboard are ignored by the Mopho.

Please advise.

Re: Mopho Dashboard Parameter Changes Work!

Posted: 22 Dec 2013 23:12
by sculptair
Well, today it works. Same hookup, same settings. Don't know why!?

Missing Lemur support for more than 256 bit messages....