MIDI Kinetics Forum

Hello,

I'm using the ROADIE T.V. template for Modul8 and i'm trying to map the SLIDER for DIVX, DIVY and THICKNESS to their appropriate functions in Modul8 under the TRANSFORMER/PATCH section.
When i map the slider to DIVX, the value change only allows changing from 1 - 2 (changing to 2 at slider all the way up position). The DIVX function in Modul8 actually has a range of 01-200. How do I get this slider to access this whole range?

thanks.

Hi
I think a post to the Modul8 support might be in order . . .
I cant get the number boxes to map properly even using hardware controllers . . .
If you have the OSC Modules they may provide better performance -
I only have the demo so I cant check that out . .

Type in value of the slider parameters: Slider1*200

Slider1 is the name of YOURS!

Cheers

Hi
Its actually not that simple - also for a range of 1-200 it would be (Slider1.x*199)+1, and you would probably want to floor() that as well . . .
And a range such as 1-200 is not available with a standard midi controller, on note so you have to go 14bit / 2*7bit values . . .
Or OSC where it is just as likely the 0-1 range would be used as the 1-200 range anyway - but I don't have the OSC plugin to check, as mentioned . .
Did you actually manage to get this to work in Modul8?