Page 1 of 1

Please help with sending program change messages from pads..

Posted: 31 Jul 2013 17:38
by stevendieveney
I haven't done anything with program changes thus far and am getting a bit frustrated. I think what I'm trying to do is fairly simple but I just can't make it work.

Basically, I've got an instrument bank in Kontakt with instruments in 10 slots (001 to 010). I want to set up a 10 pad multi-pad element that sends the proper program change numbers out. For the life of me I can't seem to get it to work.


Please help.....????

thanks!!!!!

Re: Please help with sending program change messages from pa

Posted: 31 Jul 2013 19:54
by Softcore
If this is too complicated (as usage) for your application....

http://forum.liine.net/viewtopic.php?f=34&t=3276

...then try this one!