Getting Ableton's bars and beats to display on lemur
Posted: 06 Jun 2013 06:41
Hi,
I am trying to figure out a way to get Ableton's bars and beats to appear on the lemur. One route was to set up a "fake" Mackie Control and then use the SurfaceLCD in Timecode mode. This is fine as long as my song in ableton stays in 4/4, which it doesn't.
Is there a way to accomplish this? I've been searching forums and haven't come up with anything.
Any help is greatly appreciated!
Thanks.
I am trying to figure out a way to get Ableton's bars and beats to appear on the lemur. One route was to set up a "fake" Mackie Control and then use the SurfaceLCD in Timecode mode. This is fine as long as my song in ableton stays in 4/4, which it doesn't.
Is there a way to accomplish this? I've been searching forums and haven't come up with anything.
Any help is greatly appreciated!
Thanks.