Connect two Lemurs via OSC
Posted: 04 Mar 2013 10:59
Hi,
I have two iPads with a Lemur App on both. I set the second as OSC target for the first. Port is 8000. Both lemurs have the same project loaded. All controls send to OSC 0. If I'm right, then touching a pad on the first lemur should highlight also the corresponding pad on the second. But this is not the case. Any suggestions?
Thanks,
Gabriel
I have two iPads with a Lemur App on both. I set the second as OSC target for the first. Port is 8000. Both lemurs have the same project loaded. All controls send to OSC 0. If I'm right, then touching a pad on the first lemur should highlight also the corresponding pad on the second. But this is not the case. Any suggestions?
Thanks,
Gabriel