Page 1 of 1

line6 midi mobilizer mk1

Posted: 11 Apr 2012 10:43
by eben1000uk
hello

i have a line6 midi mobilizer mk1

i would like to use lemur to control an external hardware midi synth

is there a way of doing this directly from the ipad mk1 - mobilizer mk1 - midi input of synth [buchla 225e midi decoder]?

i have tried setting this up on the ipad but cant get it to work!

thanks

ben

Re: line6 midi mobilizer mk1

Posted: 11 Apr 2012 13:12
by Phil999
I have a different interface (iRig MIDI), but it is very similar to yours. Setup is simple: in Lemur, select the hardware output in the MIDI 0 target, and the output LED on the interface should blink when you send MIDI data. It depends on the Lemur template on what target (port) the MIDI data is sent, but with most note generator templates it is MIDI 0 target. After that, you may need to check the MIDI channel the 225e is expecting. Maybe you can set it to 'omni' so that it will receive all incoming channels.