Program change question
Posted: 13 Feb 2012 06:20
Hi
I am currently using a 5 x 5 matrix of switches in radio mode to send program changes to external hardware.
What I would like to do is define specific (non sequential) program numbers for each switch in the matrix rather than use the predetermined sequence.
I assume this can be done with the appropriate script but do not know how to go about it.
Any help would be appreciated (e.g. an example script). Happy to upload the switch matrix if that helps.
Thanks in anticipation
Davpbx
I am currently using a 5 x 5 matrix of switches in radio mode to send program changes to external hardware.
What I would like to do is define specific (non sequential) program numbers for each switch in the matrix rather than use the predetermined sequence.
I assume this can be done with the appropriate script but do not know how to go about it.
Any help would be appreciated (e.g. an example script). Happy to upload the switch matrix if that helps.
Thanks in anticipation
Davpbx