Page 2 of 3

Re: Ramp Values of Switches...

Posted: 28 May 2015 03:48
by metamorfosis18
Hey I tried it but for some reason the switches don't send midi out and the fader is locked, like frozen on the iPad . Now I tried closing and opening the app again and the fader starts to go down from the top slowly and then it works. But every time I sync it with the lemur editor on laptop it happens again it does not work.
Any ideas, is this normal behavior maybe because of the coding?
If you do check it, can you help me out with the relative rate coding! :roll: I will study and analyze this example to try to understand the logic/syntax behind it!

This is brilliant work, I had been trying to do this for so long with any success, thanks a bunch man.

Re: Ramp Values of Switches...

Posted: 28 May 2015 03:55
by ndivuyo
try this


And I just tested it, MIDI is being sent out. Make sure you are using target 0, otherwise change the variable called 'target' if you want to use a different one.

will do relative later

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:00
by ndivuyo
actualyl it was super easy, here it is, with relative speed.

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:03
by ndivuyo
arg there was still an issue at startup, give me a minute

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:08
by metamorfosis18
Ok

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:10
by ndivuyo
ok, finally got it,
Runs fine at startup, is relative speed and sends midi

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:19
by ndivuyo
WAAAIIIIT
I tested it some more and it kept freezing (because value keeps going out of limits in different places)

OK I think I got it right, it's not locking for me anymore. Let me know if it works fore you

(definitely download this one, the last one had issues)

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:20
by metamorfosis18
Ok

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:27
by metamorfosis18
I tried it and it works perfectly!!
I cant thank you enough!!

You are a genius man.... I really appreciate it.

I'll send you a PM.

Re: Ramp Values of Switches...

Posted: 28 May 2015 04:47
by metamorfosis18
One last question, which script did you change to make it relative speed? was it 'timin' under 'ramp'