MIDI Kinetics Forum

It is fully send/receive osc ready, be sure to check the osc settings in Reaktor under File>OSC Settings.
In "OSC send" you must have "Lemur" under Identifier, the ip adress of Lemur and 8000 under port. You can send a test message and see in "OSC Receive" if there is a PING-PONG message under OSC Monitoring.
Hope it help.

Hello
A big thank for the support !
This was exactly what I am searching for.
Great combination this Ensemble and this Template.
Many thanks again.
Greetings.

Hey again.

There is a bug in oscillator 5 from left i A, its get stucked and cannot move.

Sorry to ear about a bug, but i have try myself to reproduce it and it doesn't append.
Can someone else confirm this and post details to reproduce it.

I have make some improvements to the template and add some features for the next update. I will try to upload it in the next days.

Hello! I'm not experienced in Reaktor, but why do OSC Receive objects connected to Separator objects without any "Thld" value ?

Perhaps am i wrong but there is no need for threshold because the value send to Osc Send is already between 0 and 1.... bur i will look at it when i find some time.

The 1.3 update is in the User Library

So, it also recieving values outside 0 to 1? Sorry for possibly noob question, what's the purpose of separation of OSC input in general?

I use Osc Send and Osc receive mostly because the Mouse Area module send x/y value and i need, in this special case, to send or receive only one value at the time.
With the 5.8 update most of the parameters of Reaktor are directly controllable without the need of Osc Send or Osc Receive. Metaphysical Function is special in this aspect because it use a lot of mouse area module instead of faders or buttons.
I hope it answer the question more or less clearly, english is not my native language.

Yes, it cleared up a lot, thanks. Actually, I started to dig your template to make feedack of automated controllers, so faders in Lemur would follow the respective faders in Reaktor. Did you plan to do it by any chance?

It is already ....!! I think you must look a little bit more in Reaktor OSC and Midi preferences in the File menu.
You have 3 tab Receive, Send and Sync (sorry i'm not in front of my daw), set the Receive port to the same as you configure in Lemur editor or setting sin app, in the send tab you must enter the ip of the lemur (find it in the lemur editor, settings, lemur) and the port must be 8000 or 8001 (??), click on test, if all is ok you must see a ping and pong on the Receive tab ...

Hope it helps ...