Hi,
I'm trying to control a bank of radio switches via OSC coming from my laptop. The OSC messages from Lemur are Switches3/x1, x2, etc. Sending that same set of messages back out only works in the case of Switches3/x and it only affects the first button. I'm able to set Multiball and Fader via bidrectional OSC, so I get the general idea and my path is set up correctly, but I'm obviously not understanding how to differentiate between the individual switches in the bank, any ideas ?
Thanks,
Jeff
Switches control via incoming OSC
Re: Switches control via incoming OSC
Hi
The address would be Switches3/x - then the values needed x1 x2 x3 x4
So the message would be Switches/x 0 0 1 0 to switch the 3rd switch of a 4 switch array
Hope that helps
MM
The address would be Switches3/x - then the values needed x1 x2 x3 x4
So the message would be Switches/x 0 0 1 0 to switch the 3rd switch of a 4 switch array
Hope that helps
MM
iMac 2.8G i7 12G 10.6.8/10.7.2, Legacy Dexter/Lemur, Liine Lemur/iPad2, KMI SoftStep, 12Step & QuNeo , B-Controls, Mackie C4 etc
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
Re: Switches control via incoming OSC
Hi,
Yep, that worked, thanks very much.
Jeff
Yep, that worked, thanks very much.
Jeff