I've just purchased Lemur app for my iPad 2 and connected it to my PC setup bu using loopmidi & ad-hoc connection. Up to here everything is fine. And I have 2 questions;
1- I am using Cubase 6.5 on my PC setuo. Is there anything to make a configuration in Cubase? I don't know what to do exactly after loading both Lemur on iPad & Daemon on PC and starting Cubase...where should I begin? Please can you give me some simple advices to make Lemur work on Cubase...
2- I need a template like this: I want a single ball with X and Y axis. X is for CC1, Y is for CC11. Is there any template like this, or should I make one?
Using Lemur with Cubase is the same as using any midi controller. I would suggest you read-up on remote devices (via devices/device setup in Cubase) and learn how to create a generic remote (and later Mackie Control), and how to correctly route the virtual connections.
Start simple, perhaps create 1 fader object in lemur and assign it to a midi CC. Then create a generic remote in cubase and set-up a target for that fader and the relevant CC#.
If you need templates head over to the User Libray via the many Liine site.
whatisvalis wrote:Using Lemur with Cubase is the same as using any midi controller. I would suggest you read-up on remote devices (via devices/device setup in Cubase) and learn how to create a generic remote (and later Mackie Control), and how to correctly route the virtual connections.
Start simple, perhaps create 1 fader object in lemur and assign it to a midi CC. Then create a generic remote in cubase and set-up a target for that fader and the relevant CC#.
If you need templates head over to the User Libray via the many Liine site.
Dear whatisvalis, thank you very much. I did it. created a generic remote at Cubase, than create a simple template at lemur editor with one ball, two axis of Y and X for CC1 and CC11 respectively, and it worked!
