Mouse Area Module in Reaktor

Discuss Lemur and share techniques.
Post Reply
Juggla+
Newbie
Posts: 13
Joined: 08 Dec 2011 03:18

Mouse Area Module in Reaktor

Post by Juggla+ »

Im a pretty new user of Reaktor, and lemur............

I would like to make a lemur iPad template of Skanner, a fun little .ens within reaktor.

All the basic knobs and buttons are pretty standard and easy to figure out, but my two main questions are how to map the center 8 buttons, which is a Mouse Area Module.

Also any creative ideas for mapping the line that moves over the sample in the GUI.

Ok actually I have some more questions :p

I would like to put the whole mapping in a container and switch from panel A and B. How can I map this?

How do you create a preset selector as well?

These are all different concepts/ techniques in Reaktor/ Lemur, so if anyone can help me answer any question that would rock the socks!

thanks,

Kyle
Phil999
Regular
Posts: 919
Joined: 11 Jan 2012 01:53

Re: Mouse Area Module in Reaktor

Post by Phil999 »

the mouse area itself is not controllable I think. One has to create a knob in Reaktor with the desired destination and control that knob. How snapshots (Reaktorpresets) and panels can be controlled I don't know. But I'm sure this can be asked in the Reaktor forum.

Good luck!
Formant+Eurorack, PPG wave 2.2, Korg MS-20, etc., EWI 4000s, QuNeo, etc., Mixbus32c, u-he, MadronaLabs, Samplemodeling, NI, etc., iPad2/4/Pro
Post Reply