Two way communication between reaktor and lemur ipad

[samgreene]

Hi,

I've got the stand alone version of reaktor working and have set up OSC as shown in the tutorial video. I can control reaktor from the lemur, but the lemur is not being updated when reaktor changes - if I were to change a preset or mouse a change in a control. From the look of the video, it seems that lemur changes to reflect the patterns switching. I got the IP and port of the lemur application from the lemur designer application and entered that into reaktor as well. Not sure what to try next if this should in fact be working.

I'm connected over a wireless router.

Thanks
Sam

[samgreene]

Popped open wireshark to see what's actually going on and I do see OSC UDP messages being sent to the iPad IP address on port 8001.

[Macciza]

Hi
Try sending to 8000 instead . . .
Cheers
MM

[lABl]

Yes, please check Macciza's advice port 8000 instead 8001.

Also a very important thing is the "Identifier Name", it should be Lemur

Here a very good tutorial by Liine in case somebody need it:

REAKTOR | LEMUR OSC SETTINGS
http://www.youtube.com/watch?v=iKtmYnCdjcQ

Cheers,

[samgreene]

Hi
Try sending to 8000 instead . . .
Cheers
MM

Thanks - that IS what it said in the tutorial. I got the port from the lemur editor, which seems to be a port for that sort of communication.

Thanks!!

[sun in aquarius]

I followed that exact tutorial and i get no communication....

[lABl]

Sorry, I am confused now, in other post you're saying you cant open the ensembles because "not a valid file" message, please may you to post more details about you're using?
thanks,