Approximating TouchOSC Xy pads

[peterdines]

Do we have some touchosc users here? What do you do in Lemur to mimic or replace the XY pads?

I'm using a multiball with a single ball but it's difficult because the z parameter stays on unless I set it to ephemeral, in which case I lose my display of position unless touching the ball. So I can't have the ball constantly displayed and also use the Z to operate a router in Reaktor like I can with TouchOSC.

I'm trying something with an ephemeral multiball and a signal scope for the display but it's difficult going. Any tips would be appreciated.

[wetterberg]

your z parameter stays on? that's odd, I can't reproduce that, neither on the legacy nor on ipad or iphone.

[peterdines]

I think it's a bug. I came back to it later and it was mysteriously working again. Think it has something to do with a long heavy development session in the Lemur editor with Lemur connection active. Or possibly an ID-10-T problem.