Sending MIDI to Monitor, SignalScope and LCDs

[MBM]

Hello, I´m using Lemur with Max/MSP and I want to send some MIDI data to these objects. How could they receive MIDI data? I can send values from other objects (for example "Fader.x") but I don´t know how to make this with MIDI sent from the computer.

Thank you and best regards.

[Psyk]

Map fader to the MIDI source you want to send to Monitor, and then assign the same midi channel and controll number to Monitor.
That`s how i do it, there`s a probably the right way to do this but i don`t know it

[MBM]

Hello,

Thank you very much but, if I make that, when I stop to sending MIDI data, the Monitor and Scope come back to zero. I send values from "ctlout" in Max/MSP, by the way.

Thank you very much and best regards.

[Psyk]

Hmm, when the car ran out of gas, it stops

you want them to remain on the current value when midi stops?

[MBM]

Yes, that´s what I want. I.e. : if I send data from a fader (with "Fader.x") the signal scope remains in its last value. But if I send from MIDI (ctlout with Max/MSP) it returns to zero always.

Thank you very much and best regards.

[MBM]

Solved. I don´t know exactly what I was doing wrong, but now it works for me.

Thank you very much, anyway

Best regards.

[Psyk]

Hey!

Then what did you do at the end...?

[MBM]

Nothing special. I just connected ctlout from Max to Lemur´s objects and assigned the correspondent values. I don´t know why it didn´t work before...

Thanks and best regards.