Hello!
This is the only forum i found that still talks about legacy lemur, so i'll try my luck here despite the lack of posts and support on the legacy forum.
I've been a long time user of legacy lemur. Everything was working ok until a couple of months back.
Out of the blue, my lemur just started to freeze minutes after i start working (both midi and osc). If i turn it off, then on again I get a black screen with only the 2 buttons on the middle red (page and previous page buttons). If i wait a little bit and try again, it starts ok, then i start working and a few minutes later - freeze!!!
I try to replace the power supply and ethernet cables but the issue is still happening. I'm on mac osx 10.8.5 and 10.9.5 (but i think this is not the problem). I think it is an issue with ethernet, but i cannot figure it out :/
Is my lemur dying? Anyone else had this issue?
Thank you!!!!
Legacy lemur freeze
Re: Legacy lemur freeze
hum... no one as any input on this?... :/
Re: Legacy lemur freeze
Hi
I have a legacy lemur but have not had issues with it yet....
Try writing to Liine support, I think Nick may have details on Lemur competent repairers, maybe . . .
Good luck
MM
I have a legacy lemur but have not had issues with it yet....
Try writing to Liine support, I think Nick may have details on Lemur competent repairers, maybe . . .
Good luck
MM
iMac 2.8G i7 12G 10.6.8/10.7.2, Legacy Dexter/Lemur, Liine Lemur/iPad2, KMI SoftStep, 12Step & QuNeo , B-Controls, Mackie C4 etc
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
Re: Legacy lemur freeze
thank you for your input, i'll do that!
Re: Legacy lemur freeze
Sorry for the late response on this dead forum.
I would try reinstalling Lemur firmware on the device.
I would try reinstalling Lemur firmware on the device.
lightlabstl.com