The template and all the controls to Operator which the script alters are hardcoded to midi channel 2 but I am getting a bug/unwanted side effect where midi control messages on channel 1 are coming through when I tap the button, controller numbers 6 & 7 (checked with Midi Monitor). This is then messing with Ableton Analog on another track in Ableton. Are these being added by iConnect Midi 4+ (my Midi Controller) or is this standard behaviour? If no-one can help, I guess I should just change the mapping I've set up for Analog but hope I don't have to.
I've check for unwanted Z variables, couldn't see any yet. There is no Z variable under that button, only x, there are some in the knob controls but they are unmapped to midi via target, but still mapped to object target.
I've attached what I see in Midi Monitor when I press the button, I've filtered all the wanted channel 2 messages that occur, leaving the channel 1 ones. Can't figure this out at all..
Actually, now I've really figured it out- freq and multi were hidden knobs behind the coarse and fine knobs, I had not changed them to channel 2 when I remapped the template in Ableton. DoH.