script getting evalated twice for pads?

[leehu]

Hi, in the following patch I get the following output:

osc: test 1.
osc: /Pads/x 1.
osc: test 1.
osc: test 0.
osc: /Pads/x 0.
osc: test 0.

The normal x message is sent as expected, but my on_action() script appear to be evaluated twice on the pad down, and twice on the pad up...
Can someone else give this a go?

thx

[Macciza]

Hi
What are you monitoring with? You need to log, not watch values . . .
The project looks fine - OSC messages are fine in Max here ...
MM

[leehu]

the output comes from printing out the OSC input stream in Max, i.e. the output of the test message is being logged twice...

"You need to log, not watch values . . ."

are there any internal logging functions? not quite sure what you mean here

[Macciza]

Hmm
In a basic Max patch?
I just used udpreceive into both a capture and a print and both look fine. Try the simplest system possible and make sure it is only patch open.
If printing to the Max window you should be able to click the arrow and get it to tell you which object sent that message . .
Sorry but it all looks good at this end.

temp.tiff (82.89 KiB) Viewed 1622 times

Just meant that you need to record values somehow not just watch them changing onscreen if that was the case . . .

[leehu]

cant't see the tiff for some reason...

yeah, that's why it's so freaky

it is the only stuff running... i'm going to reboot and try again this eve. thx

[leehu]

Hi, I rebooted and retried this - the test message gets output twice.