@ Macciza: No worries dude, at least it gave you an excuse to bust out the ubiquitous elipsis eh? .
@ Prokat99: I can address / control my RME Fireface using the template from the User Lib over OSC with no problems whatsoever - in fact I was surprised at how straightforward it was - just loaded the template, pointed the OSC Target at the IP specified and Bob's yer Auntie's transgender 'friend'.
The only other possibility I can think of is my wifi router. I will have to test with another and see what happens.
TO working perfect doesn't make sense though. I guess I will keep at it.
Hi
It must be an addressing issue because I can get both to work sending Max on my Mac . . .
So in TO I guess you are seeing the X32 as a 'Found Host' and selecting it;
What IP address shows upon the Host field at the top? e.g. 192.168.0.100
Port field is then set to 10023.
In Lemur you would set say OSC 0 Target to Host: 192.168.0.100 Port: 10023
Then set Fader up using OSC 0 as Target for x value
OSC panel.tiff (19.43 KiB) Viewed 1180 times
Make sure the x variable is ticked (default) in the project hierarchy panel
Both of these setups should send the same thing to the same place.
.