Hi, pls see attached patch. The oscout command sends out the expect result, but the assignment to out always sends out 0. This was working fine in Lemur 4.
Can you take a look? thx
Output issue in Lemur 5
Output issue in Lemur 5
- Attachments
-
- test.jzml
- (1.95 KiB) Downloaded 59 times
Re: Output issue in Lemur 5
Hi
Working fine in 5.0.2
section should be able to be used to send OSC, no need for the out = selection as such (except readability) as it is the same as selection . . .
Also remember the / if you want it to be proper OSC . . .
MM
Working fine in 5.0.2
section should be able to be used to send OSC, no need for the out = selection as such (except readability) as it is the same as selection . . .
Also remember the / if you want it to be proper OSC . . .
MM
iMac 2.8G i7 12G 10.6.8/10.7.2, Legacy Dexter/Lemur, Liine Lemur/iPad2, KMI SoftStep, 12Step & QuNeo , B-Controls, Mackie C4 etc
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
MaxMSP, Live Suite, Native Instrument stuff, etc Modified Virtual Guitar System etc All Projects/Modules © CC-BY-NC-SA[*][/b]
Re: Output issue in Lemur 5
great will check it out
they're only test patches so just looking to see what is output - not sposed to be proper OSC
thx
they're only test patches so just looking to see what is output - not sposed to be proper OSC
thx