midi monitor app for checking output fo lemur app

[zeropoint]

hey all, is there a midi monitor app out there that works with lemur ? i got midi wrench to work a couple of times but since then, no matter how i route things i don't get anything showing in wrench. i've tried "midi monitor" app too. no dice. or is this just a general problem with how lemur addresses coremidi apps ? thanks.

[Macciza]

Hi
What are you trying to achieve? There really is no general problem with coremidi apps that I am aware of.
Of course it depends on how Lemur is setup and what and how the other app monitors . . .

MIDI Wrench works - you simply have to set up your Lemur MIDI target to point to it . . .
Midi Monitor (iPad app) - I don't think it will do it - it doesn't advertise

If you are on a Mac then MIDI Monitor is your best option for computer based monitoring . . .

You can always loopback MIDI on the iPad in various other ways, which comes back to 'What are wanting to do??'

Cheers

[zeropoint]

I'm combining some templates and just want to check outputs to avoid conflicts and ideally without using a computer. I have midi wrench running on an iPad 3 iOS 6.1.3. In the midi target I have" from" as unassigned " or "session 1 " and "to" as midi wrench. It worked briefly twice but now, no matter what the boot order, soft reset etc, no midi stream shows up. Are my settings correct ? Thanks