Using multiple deamon on same computer, is it possible?

[martinpatino]

Hi guys
here is a probably simple question, but cannot find an answer myself..

Is it possible to send, from the same project in Lemur, for example
CC 1=; Midi CH=1; Target= Midi 0
and
CC 1=; Midi CH=1; Target= Midi 1
each of them to different parameter in the same computer running Live?

So basically, can I send 128x16 Control Change, or 128x16x8 Control Change?
Thanks!!

[Macciza]

Basically yes but its not multiple daemons its 1 daemon with multiple midi ports . . .
Yes plus MIDI Notes Aftertouch PitchBend etc but remember some CCs are kinda reserved . .
The Daemon is 8 separate virtual MIDI ports, each with 16 channels etc etc....
The Daemon can receeve data from different devices or places and send it out as the Daemon output . ..
Hope that helps

Cheers
MM

[martinpatino]

thank you!
I guess the problem of my previous configuration was setting all deamon as REMOTE (in LIVE), there is where the mess comes from, two messages, both ch1 cc1 on different midi ports were not recognized as different